(b) Enhancement ratios of Mg and H concentrations by the MSE tech

(b) Enhancement ratios of Mg and H concentrations by the MSE technique as a function of Al content compared with that of the conventional method. High Mg doping was reported to result in Mg-rich precipitates. The primary Mg-rich precipitates were presumed to be Mg3N2[27, 28], which can be formed when Mg do not incorporate as acceptors in the desired substitutional sites. The see more substitutional Mg was suggested to be usually passivated by H during growth, and the corresponding Mg acceptor can be activated by postgrowth thermal annealing to dissociate the Mg - H complex [29]. The correlation Vistusertib mw between

the substitutional Mg and H was verified by previous theoretical and experimental investigations [30, 31]. Thus, the H concentration is most likely associated with C Mg if Mg is effectively incorporated in the desired substitutional sites. The enhancement ratios of H concentration for the MSE technique increase from 1.2 to 10 with increasing Al content, compared with that of the conventional method, as shown in Figure 4b. This simultaneous enhancement in H concentration demonstrates that the Mg was effectively incorporated in the desired substitutional sites

by the MSE technique. In this work, the high C Mg is the important basis for improving the hole concentration in p-type AlGaN epilayer. Besides the solubility limit, the high activation energy of Mg acceptors is another contribution for the low p-type doping of Al x CFTR modulator Ga1 – x N, leading to a low acceptor activation probability [5, 8]. In order to increase the overall p-type doping, more efforts on activating the obtained high C Mg will be included in future progress. Conclusions The MSE technique, which utilizes

periodical interruptions under an extremely N-rich atmosphere, was proposed to enhance Mg incorporation, base on the first-principles total energy calculations. During the interruption, metal flows were closed to produce an ultimate V/III ratio condition without affecting Acetophenone the AlGaN growth. By optimizing the interruption conditions, we obtained a high concentration and uniform distribution Mg in the AlGaN epilayer. The C Mg enhancements increase with increasing Al content through this method. Particularly, for the Al0.99Ga0.01N, the enhancement ratio can be achieved up to about 5 and the final Mg concentration was determined to be 5 × 1019 cm–3. Meanwhile, the simultaneous increase of the H concentration confirms the Mg effective incorporation in the desired substitutional sites instead of forming Mg3N2. The proposed approach, which is convenient as well as effective, could be used as a general strategy to promote dopant incorporation in wide bandgap semiconductors with stringent dopant solubility limits.

Comments are closed.