The teeth restored with selective bonding technique showed lower

The teeth restored with selective bonding technique showed lower values of cuspal movement and an intermediary quality control layer of flowable composite did not show any influence on the cuspal movement. No differences were found between the materials of each category (etch-and-rinse and self-etch), except between SMP and SB totally bonded associated to flowable composite. Table 2 Means of cuspal displacement (��m), standard deviation (SD) and coefficient of variation (%) for the etch-and-rinse adhesives (SMP and SB). Within each line, different lower case letters mean statistically difference; within each column, different … Table 3 Means of cuspal displacement (��m), standard deviation (SD) and coefficient of variation (%) for the self-etch adhesives (CSEB and CS3).

Within each line, different lower case letters mean statistically difference; within each column, different … DISCUSSION It is largely accepted that volumetric contraction during polymerization of restorative composites in association with bond to the hard tissues results in stress transfer and inward deformation of the cavity walls of the restored tooth.10 Mechanical stresses produced by shrinkage of the composite restorative material associated to high adhesive bond strengths may be transmitted to the surrounding tooth structure.11 In total bonding technique, if the adhesion is stronger than the polymerization shrinkage stress and/or stresses under function, the interface between restoration and tooth remains perfectly sealed. However, shrinkage stresses may become higher than the bond strengths, resulting in partial debonding of the adhesive from the tooth surface.

6 Total bonding technique is the simplest adhesive technique and may be indicated in restorations with a small volume and/or a low C-factor (fissure sealing, small class I and III composite restorations, large flat onlays). Selective bonding is better indicated for large class I and III composite restorations and for class II composite fillings, inlays and small onlays.6 Selective bonding technique creates free surfaces within the cavity, thus reducing the C-factor of the restoration. It has been suggested the use of glass-ionomer cement (GIC) as a liner or base in the selective bonding technique. The GIC can seal dentin and must be insulated to prevent this material from adhering to the restorative composite.

In the present study, when proceeding with selective bonding technique, the same adhesive system to be tested was used as a dentin sealer, followed by refinishing of the margins and a new bonding procedure on the freshly cut tooth surface. Anacetrapib The adhesion between the two coats of adhesive system was prevented by the contamination of the first surface by water and contaminants created during the refinishing procedure. It is accepted that beveling of enamel margins decreases the risk of marginal gaps, microleakage and enamel fractures.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>