1,11 Turssi et al12 implied that in

1,11 Turssi et al12 implied that in method comparison with minifilled composite, smaller particles might had been sheared off in nanocomposite and smaller voids might had been left on its surface, consequently more even and smoother surfaces had been created. On the other hand, studying the effect of these burs on different types of composite resin materials in further studies can be clinically beneficial. New instruments like burs out of a resin reinforced by zircon-rich glass fiber have been introduced for various uses and some of their properties were mentioned in the introduction part. They are introduced as non effective to soft tissues as they slide over them without cutting or grinding. This quality, and the fact that the instrument hardly heats up during use, makes the process virtually pain free, hence its easy acceptance by patients compared to other instruments and methods.

But again according to the manufacturer, they act as grinding instruments grinding layer after layer not as cutting burs. Therefore, to be efficient, they must be used at low speed with little pressure. High speed and strong pressure would only lead to faster wear, clog the spaces between the fiber sections and would lessen their abrasive power. In this study these burs were used for finishing of composite samples and a quantitative analysis of the finishing result was performed with a surface tester. Profilometer is a widespread method in evaluating the surface roughness of composite materials.

1,2,10,13�C18 It provides limited two-dimensional information, but an arithmetic average roughness can be calculated and used to represent various material-finishing surface combinations that assist clinicians in their treatment decisions.1 However, according to the same authors,1 the complex structure of a surface can not be fully characterized by the use of only surface roughness measurements. Therefore it is not appropriate to draw conclusions on the clinical suitability of a finishing instrument exclusively based on average roughness results. However, in combination with SEM analysis that permits an evaluation on the destructive potential of a finishing tool, more valid predictions of clinical performance can be made. In this study sample surfaces were evaluated also by means of SEM and results of profilometric measurements were largely confirmed by these analyses.

But sometimes there can be a difference between the profilometric results and SEM images. According to Tate and Powers,17 AV-951 this difference may be due to surface waviness produced by the treatments. The profilometer detects any waviness within the 0.25 mm cut-off, which would increase the Ra, however SEM can not distinguish overall surface texture. In this study the cut-off value was 0.8 mm. It can be expected that because of this cut-off value there is minimum difference between the profilometric evaluation and SEM analyses.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>